| HP Z600 Workstation Motherboard Systemboard Ass# 460840-002 Sp# 461439-001 |
| |
|
| Manufacturer |
HP |
| Assembly number |
460840-002 |
| Spare number |
461439-001 |
| SKU |
460840-002 |
| |
|
| Package |
| Condition |
Refurbished |
| Contents |
Motherboard only |
| Warranty |
30 days |
| |
|
| Specifications |
| Form factor |
36 x 28 cm / 14.2 x 11 inches |
| Processor socket |
Dual LGA 1366 |
| CPU bus speed |
QPI: Up to 6.4GT/second, depending on processor |
| Chipset |
Intel 5520 |
| Super I/O controller |
SMSC SCH5327, Rev B |
| Memory Expansion Slots |
6 (3 per processor) |
| Memory Type Supported |
DDR3, UDIMM (Unbuffered), ECC: 1GB, 2GB, and 4GB
DDR3, RDIMM (Registered), ECC: 4GB and 8GB |
| Memory Modes |
NUMA (Non-Uniform Memory Architecture), Memory Node Interleave |
| Memory Speed Supported |
800, 1066, & 1333MHz |
| Maximum Memory |
Supports up to 48GB |
| PCI Express Connectors |
2 PCI Express x16 Gen2 graphics
1 PCI Express Gen2 (x8 mechanically, x4 electrically)
1 PCI Express Gen1 (x8 mechanically, x4 electrically) |
| PCI Connectors (5.0V) |
2 full length 33 MHz 32-Bit |
Supported Drive
Interfaces |
Integrated 6-channel SATA 3.0Gb/sec controller with RAID 0, 1, 5, 10 and NCQ. (Factory integrated RAID is Microsoft Windows only) |
| Integrated RAID |
Integrated SATA RAID
RAID 0, RAID 1*, RAID 5, RAID 10
Supports one RAID array with 2-4 drives
RAID 0 configuration - striped array (supported and
configure to order)
RAID 1 configuration - mirrored array (supported and
configure to order)
RAID 5 parity striping (supported but not configure to
order)
RAID 10 striped and mirrored array (supported but not configure to order) |
| Network Controller |
Controller Broadcom 5764 PCI-E LAN Controller
Memory Integrated 48KB receive buffer and 8KB transmit
buffer
Data rates supported 10/100/1000 Mb/s
Compliance IEEE 802.3, 802.3AB and 802.3u compliant, 802.3x
flow control
Bus architecture PCIe 1.0a
Data path width X1
Data path speed 2.5Gbit per sec per direction transfer rate
Data transfer mode Bus-master DMA
Power requirement 1.0 watts @ +3.3V AUX supply
Boot ROM support Yes
Network transfer rate 10BASE-T (half-duplex) 10 Mb/s
10BASE-T (full-duplex) 20 Mb/s
100BASE-TX (half-duplex) 100 Mb/s
100BASE-TX (full-duplex) 200 Mb/s
1000BASE-T (full-duplex) 2000 Mb/s |
| USB connectors |
Rear - 6
Front - 3 |
| HD Integrated Audio |
High Definition Integrated Realtek ALC262 Audio with Line in, Line Out, Microphone, Headphone
Line-in, Line-out, Mic-in x2, and Headphone jacks |
| |
|
|
